Longevity3 min readBy Juan Manuel Rovira de Miguel
RFD: why fast strength matters as we age
What RFD (rate of force development) is, why it declines earlier than maximal strength with age and how to measure and train it.
When we trip, we have a few tenths of a second to take a step and avoid falling. In that time what matters is not how much force we can produce, but how much we can produce very quickly. That capacity has a name: RFD, short for rate of force development.
What RFD is
If you record force while someone squeezes a dynamometer or pushes against a fixed resistance, you get a curve: force rises from zero to a maximum. RFD is the slope of that rise, that is, how many newtons or kilograms per second are gained. It is usually calculated over the early phases, for example between 0 and 100 or between 0 and 200 milliseconds from the onset of the effort.
Two people with the same maximal strength can have very different RFDs: one reaches their peak in 300 ms and the other in one second. The first responds much better to a loss of balance.
Why it matters as we age
With age we do not just lose strength: above all we lose the ability to produce it quickly. Reid and Fielding (2012) put it this way: muscle power declines earlier and faster than strength, and peak power is an important predictor of functional limitations in older adults.
Part of the explanation lies in muscle fibres: fast fibres, the ones that generate explosive force, are the ones lost most over the years (we explain this in muscle fibre types). The other part lies in the nervous system, which activates muscles more slowly.
The result is that a person can have acceptable maximal strength and still struggle to get up from a chair, climb stairs slowly or fail to react in time to a trip.
How it is measured
Measuring RFD requires a sensor that records force many times per second. At 10 or 20 samples per second the rise looks blurred; laboratory equipment works at hundreds or thousands of samples per second. The review by Maffiuletti et al. (2016) on RFD stresses careful methodology: instructions to push “as fast and hard as possible”, avoiding pre-tension and clearly defining contraction onset.
In practice it is measured with:
- Grip, using a digital dynamometer.
- Isometric contractions of the legs or arms against a fixed resistance.
- Jumps, using force plates (more common in sport).
How to train it
The good news is that power responds to training at any age. The key is intent: moving moderate loads as fast as possible in the pushing phase, with good technique and in safe settings such as guided machines. Measuring the velocity of each repetition helps keep that intent and stop before fatigue reduces it (we explain it in VBT on machines).
Measuring RFD with Tratech
- HandGrip records the grip force curve at 320 samples per second and shows RFD and time to peak force in real time.
- Wellness Bench measures isometric pushing and pulling strength of the arms and legs and calculates RFD and side-to-side asymmetries.
Frequently asked questions
What is RFD?
RFD (rate of force development) is how quickly force is developed: the slope of the curve rising from zero to maximal force. It is usually calculated over the first 100 or 200 milliseconds.
Why does RFD matter as we age?
Because muscle power declines earlier and faster than maximal strength, and it predicts functional limitations in older adults. Fast fibres are lost the most.
How is RFD measured?
With high-frequency sensors, such as a digital grip dynamometer or measured isometric contractions, asking the person to push as fast and hard as possible.
Can RFD be improved in older adults?
Yes. Power responds to training at any age, by moving moderate loads with good technique and maximum velocity in the pushing phase.
References
- Reid KF, Fielding RA. Skeletal muscle power: a critical determinant of physical functioning in older adults. Exerc Sport Sci Rev, 2012.
- Maffiuletti NA et al. Rate of force development: physiological and methodological considerations. Eur J Appl Physiol, 2016.

