Performance3 min readBy Juan Manuel Rovira de Miguel
Resistance band training: how to measure the load
Resistance bands deliver the same strength gains as machines and weights, but their load is hard to know. Here is how to measure it and progress with data.
Resistance bands are cheap, light and fit in a drawer. They are used in physiotherapy, home training, with older adults and with athletes. Their weak point has always been the same: we do not know how much they weigh.
Do they work as well as weights?
Yes, as far as strength is concerned. A meta-analysis by Lopes et al. (2019) pooled 8 trials comparing training with elastic bands or tubing against machines and dumbbells. There were no differences in strength gains in either the lower or the upper body. The authors conclude that elastic resistance training produces similar strength gains across different populations and protocols.
One example is the trial by Colado et al. (2010): 42 young women trained for 8 weeks on an identical programme, some with elastic tubing and others with machines and free weights, and improved their isometric strength comparably.
The problem: you cannot see the load
With a dumbbell you know you are lifting 8 kg. With a band, the resistance depends on:
- The colour or thickness of the band (and each manufacturer uses its own code).
- How far you stretch it: the longer it gets, the more it resists.
- Where you start from: initial tension changes with the distance to the anchor point.
- Wear: with use, the rubber loses elasticity.
The result: two “identical” sessions can have very different loads, and it is hard to know whether a person is progressing or has simply stood closer to the anchor.
How to control the load without a sensor
- Always use the same band for an exercise and write down its colour.
- Mark on the floor where you stand and keep that distance.
- Use the rating of perceived exertion: score from 0 to 10 how hard each set was.
- Progress by changing only one thing at a time: more repetitions, more distance or the next band.
It works, but it is still an estimate.
How to measure the load with a force sensor
A sensor placed between the band and the anchor, or in the handle, measures the actual force at every moment. That lets you:
- Know the real load, in kilograms or newtons, in every repetition.
- Compare sessions even if the band or position changes.
- Do measured isometrics: push or pull against a taut band and see the maximal force — useful for both assessment and training.
- Compare sides, very valuable in rehabilitation (we explain it in strength asymmetries).
- Motivate: seeing force on screen, with targets and games, helps the person put full effort into every repetition.
PowerBand
PowerBand is Tratech’s sensor for resistance-band training and isometric exercises. It measures force in real time and adds gamification to keep motivation up in every session, in both training and rehabilitation.
Frequently asked questions
Are resistance bands as good as machines for gaining strength?
Yes. A meta-analysis of 8 trials (Lopes et al., 2019) found no differences in strength gains between elastic bands and machines or dumbbells, in either the upper or the lower body.
Why is it hard to know what load a resistance band provides?
Because it depends on the colour or thickness (each manufacturer uses its own code), how far it is stretched, the distance to the anchor and the wear of the rubber.
How do you control progression with bands?
By always using the same band, marking the starting position on the floor, rating effort from 0 to 10 and changing only one variable at a time. A force sensor makes it possible to measure the real load in kilograms or newtons in every repetition.
References
- Lopes JSS et al. Effects of training with elastic resistance versus conventional resistance on muscular strength: a systematic review and meta-analysis. SAGE Open Med, 2019.
- Colado JC et al. A comparison of elastic tubing and isotonic resistance exercises. Int J Sports Med, 2010.

